保養三坐標開機前和開機后都應該注意的事項如下:
1、該產品對于環境的要求是很高的,因此我們必須進行嚴格的溫度控制,對周邊的適度情況進行詳細的測量。
2、三坐標內部的軸承選用要求必須進一步提高,主要是其工作的特性使得發生磨損的幾率較大,為了保證正常的使用必須進行定期的檢查工作。
3、因其對加工精度的要求較高,所以?xún)炔康那鍧嵐ぷ饕彩俏覀儾坏貌蛔⒅氐膬热荨?br/>4、為了更好的起到保養三坐標的效果,我們需要經常性的添加潤滑油產品以保證其正常的使用。
開機后:
正確使用三坐標測量機對其使用精度、壽命起到關鍵作用,應注意以下幾點。
?。?)工件吊裝前,要將探針退回坐標原點,為吊裝位置預留較大的空間;工件吊裝要平穩,不可撞擊三坐標測量機任何構件。
?。?)正確安裝零件,安裝前確保符合零件與測量機的等溫要求。
?。?)建立正確的坐標系,保證所建的坐標系符合圖紙的要求,才能確保所測數據準確。
?。?)當編好程序自動運行時,要防止探針與工件的干涉,故需注意要增加拐點。
?。?)對于一些大型較重的模具檢具,為避免工作臺長時間處于承載狀態,測量結束后應及時吊下工作臺。
上一篇 : 刀具預調儀的適用場合
下一篇 : 激光對中儀解決旋轉設備軸/孔對中的好處