氣動量?jì)x是單一尺寸的測量,如果是一個范圍內的測量,有十幾個或幾十個參數,那就不適合選擇該設備,它屬于一種非接觸性測量,如果你的工件沒有非接觸性測量的條件也不適合使用。
對于工件內徑粗糙度較大時,一般建議采用接觸式氣動測量。這樣既可以讓測量點位置保持不動,同時能保護工件內壁與測量頭之間摩擦而產生磨損。接觸式氣動測量條件有工件測量面粗糙度大于Ra1.6以上,測量面面積在φ5mm以下。
氣動測量是根據流體靜力學和流體動力學原理,用壓縮空氣作介質,對長度尺寸進行測量的裝置。被應用于汽車工業中高精度大批量的工件測量。在測量工作中測量頭與被測表面不是直接接觸,這樣不但減少測量力對測量結果的影響。
氣動量?jì)x的測量是比較測量法。該測量方法是將長度信號轉化為氣流信號,通過有刻度的玻璃管內的浮標示值,稱為浮標式氣動測量?jì)x;或通過氣電轉換器將氣信號轉換為電信號由發光管組成的光柱示值,稱為電子柱式氣動測量?jì)x。氣動量?jì)x是一種可多臺拼裝的量?jì)x,它與不同的氣動測頭搭配,可以實現多種參數的測量。